MBD-05 Bogie lifting and rotating equipment It is a product designed and produced as a special production to be used for welding and maintenance operations of different types of bogies up to 5 tons capacity or any product.
MBD-05 has a piano type control panel and a remote control.



MBD-05 has main control board and remote control.
The bogie lifting and rotating equipment has 3 different movement capabilities independent of each other.
a) Equipment table up-down movement;




b) Equipment table rotational movement (Link Rod Rotation);



c) Equipment table rotational movement (Skid Plate Rotation);



The bogie lifting and turning bench is not portable and is fixed to the floor to be installed through the holes in the floor sheet.



Safety measures in MBD-05;

Height Limit Conditions: There are lower (minimum) and upper (maximum) limit switches on each bogie lifting and turning bench, and each of these switches is positioned as two. In case of not detecting any of the limit switches, the backup switch is activated.

Obstacle at the Bottom: If there is any object under the body or arm during the lowering process of the bench, these switches activate and the movement stops automatically. In these cases, the operator cannot make the jacks move down even if he wants to, but he can make the jacks move upwards in order to get rid of the load.

Failure Status of Carrier Nut: It is activated in case of a possible malfunction of the carrier nut on the machine and in this case, the operator cannot continue the lifting process. The malfunction can be seen on the PLC screen. In case of damage to the main nut, the safety nut under the carrier nut takes the load and allows the suspended load to be lowered safely.
There is 1 safety nut on each jack stand apart from the main carrier nut.